Hi Denis,
Put flag for in storage type as suggested by manish,
And then when you flag capacity check at storage type level you can update below data at storage bin level. complete explanation as below.
Capacity information
You define the maximum weight, volume, and total capacity (in dimensionless
units) of the bin that is checked during the putaway for determination. As soon
as you maintain the weight and volume information on the storage bin, the
total weight and volume of the products in the bin will be checked against the
maximum weight and volume, and if either is exceeded, the putaway would
not be allowed. The only exception occurs if you specify in the storage type
that the weight and volume should not be checked. The weights, volumes, and product capacities
are specified in the product
Regards
Suraj